Bearing support arms reduce the risk of the bearing toppling during heating, and ergonomically designed yokes help reduce operator fatigue. In addition, the remote control enables the operator to control the heater at a safe distance from the hot workpiece, enhancing operator safety.
Use the digital control to set the temperature from 230° to 482° F. This heater uses magnetic induction for even heating and automatically demagnetizes bearings. Slide the bearing onto the crossbar and place the temperature probe on the bearing. The heater beeps and shuts off when the set temperature is reached. It comes with three crossbars to accommodate a range of IDs.
Available with us is an assortment of Bearing Heater that is designed for the purpose of heating the bearings and other shrink-fit components, before their mounting while employing the latest technology micro controller based electronic controls. The rough handling and faulty installation or mounting methods may result in
DA:35PA:42MOZ Rank:14
Comparing Oil Bath to Induction Bearing Heating for Proper ...
In order to heat a bearing for proper bearing installation, you can use multiple methods.In this case I will compare using an Oil Bath Heater to using an Induction Heater. In an Oil Bath Heater you need a container which will be filled with oil and heated in order to place a bearing in the hot oil to heat the bearing.
SKF 729659C/230V Hotplate Bearing Heater: The SKF electric hot plate 729659C is intended for heating bearings and other machine components prior to mounting. It is suitable for components [show more]...
Oil baths often take a long time to reach the required temperature and can be difficult to control the actual bearing temperature. The energy consumption of an oil bath is also significantly greater than using an induction heater. The risk of contaminating the bearing due to dirty oil is significant and can lead to premature bearing failure.
Large bearing heater with high heating capacity of up to 300 kg bearing Capable of heating a 220 kg (460 lbs) bearing in just 20 minutes. Supplied standard with two yokes, allowing bearings with a bore diameter from 60 mm (2.3 in) up to a maximum weight of 300 kg (660 lbs) to be heated.
The oil bath shrink fit process requires extra time and cost to clean the bearing, even with the use of new oil. NSK’s induction bearing heaters heat cleanly and retain the original pre-lubrication, even on grease sealed bearings, without the use of oil. Oil storage management is not required, thereby improving the working environment. 1 2 3 ...
